Awasome How To Replace Wax Ring On Toilet Ideas
How to Replace Wax Ring on Toilet in 2023
Replacing the wax ring on a toilet is a job that many homeowners dread, but in actuality, it's not that difficult. The wax ring seals the drain flange from the toilet to the drain pipe, and if you don't replace it when needed, you could wind up with a leaky toilet and a messy floor. The good news is that in 2023, you have access to tools and supplies that make replacing a wax ring a much easier job than it used to be.
Materials You Need
Before you can replace the wax ring, you need to make sure you have the right supplies on hand. A new wax ring, some petroleum jelly, a putty knife, a basin wrench, a plunger, a bucket, and an adjustable wrench are all things you will need to complete the job. You may also need a hacksaw if the closet bolts are too long.
Prepare for Replacement
Before you can replace the wax ring, you need to get ready. Start by turning off the water supply to the toilet and draining out the tank and bowl. Then use the plunger to force out any water that may be stuck in the drain pipe. After that, disconnect the water supply line from the tank, and then remove the two closet bolts with the adjustable wrench. Set the toilet aside and make sure the flange is clean and free of debris.
Installing the Wax Ring
Now you are ready to install the wax ring. Start by placing a small amount of petroleum jelly inside the drain flange. This will help the wax ring adhere better. Next, take the wax ring and press it onto the flange, making sure that the sealing beads are facing up. Make sure the wax ring is centered on the flange before you go any further.
Putting the Toilet Back in Place
Once the wax ring is in place, you can start to put the toilet back in the same place it was before. To do this, you'll need to use the basin wrench to secure the closet bolts to the flange. Tighten the bolts, but not too much as this could cause the wax ring to crack. Once the toilet is in place, you can reconnect the water supply line and turn the water back on.
Caulk and Test
Once the toilet is back in place, you can apply a bead of caulk around the base of the toilet. This will help keep water from leaking out. Finally, flush the toilet a few times to make sure the wax ring is sealed properly and that there is no water leaking out. If you find any leaks, you can re-tighten the bolts or replace the wax ring.
Conclusion
Replacing the wax ring on a toilet may seem like a daunting task, but in 2023, it's not as hard as it used to be. With the right tools and supplies, you can easily replace the wax ring and make sure your toilet is sealed properly. Just remember to take your time and follow the steps outlined above.
Post a Comment for "Awasome How To Replace Wax Ring On Toilet Ideas"